Solaris Express Installation Guide: Network-Based Installations
Previous Next

Document Information

Preface

Part I Planning to Install Over the Network

1.  Where to Find Solaris Installation Planning Information

2.  Preconfiguring System Configuration Information (Tasks)

3.  Preconfiguring With a Naming Service or DHCP

Part II Installing Over a Local Area Network

4.  Installing From the Network (Overview)

5.  Installing From the Network With DVD Media (Tasks)

6.  Installing From the Network With CD Media (Tasks)

7.  Installing Over the Network (Examples)

8.  Installing From the Network (Command Reference)

Part III Installing Over a Wide Area Network

9.  WAN Boot (Overview)

10.  Preparing to Install With WAN Boot (Planning)

11.  Installing With WAN Boot (Tasks)

12.  SPARC: Installing With WAN Boot (Tasks)

Task Map: Installing a Client With WAN Boot

Preparing the Client for a WAN Boot Installation

To Check the net Device Alias in the Client OBP

Installing the Client

To Perform a Noninteractive WAN Boot Installation

To Perform an Interactive WAN Boot Installation

To Perform a WAN Boot Installation With a DHCP Server

To Perform a WAN Boot Installation With Local CD Media

13.  SPARC: Installing With WAN Boot (Examples)

14.  WAN Boot (Reference)

Part IV Appendixes

A.  Troubleshooting (Tasks)

B.  Installing or Upgrading Remotely (Tasks)

Glossary

Index
Chapter 12

SPARC: Installing With WAN Boot (Tasks)

This chapter describes how to perform a WAN boot installation on a SPARC based client. For information about how to prepare for a WAN boot installation, see Chapter 11, Installing With WAN Boot (Tasks).

This chapter describes the following tasks.
Previous Next