System Administration Guide: IP Services
Previous Next

Document Information

Preface

Part I TCP/IP Administration

1.  Solaris TCPIP Protocol Suite (Overview)

2.  Planning an IPv4 Addressing Scheme (Tasks

3.  Planning an IPv6 Addressing Scheme (Overview)

4.  Planning an IPv6 Network (Tasks)

5.  Configuring TCP/IP Network Services and IPv4 Addressing (Tasks)

6.  Administering Network Interfaces (Tasks)

7.  Enabling IPv6 on a Network (Tasks)

8.  Administering a TCP/IP Network (Tasks)

9.  Troubleshooting Network Problems (Tasks)

10.  TCP/IP and IPv4 in Depth (Reference)

11.  IPv6 in Depth (Reference)

Part II DHCP

12.  About Solaris DHCP (Overview)

13.  Planning for DHCP Service (Tasks)

14.  Configuring the DHCP Service (Tasks)

15.  Administering DHCP (Tasks)

16.  Configuring and Administering DHCP Clients

17.  Troubleshooting DHCP (Reference)

18.  DHCP Commands and Files (Reference)

Part III IP Security

19.  IP Security Architecture (Overview)

What's New in IPsec?

Introduction to IPsec

IPsec Packet Flow

IPsec Security Associations

IPsec Protection Mechanisms

IPsec Protection Policies

Transport and Tunnel Modes in IPsec

Virtual Private Networks and IPsec

IPsec and NAT Traversal

IPsec and SCTP

IPsec and Solaris Zones

IPsec Utilities and Files

Changes to IPsec for the Solaris 10 Release

20.  Configuring IPsec (Tasks)

21.  IP Security Architecture (Reference)

22.  Internet Key Exchange (Overview)

23.  Configuring IKE (Tasks)

24.  Internet Key Exchange (Reference)

25.  Solaris IP Filter (Overview)

26.  Solaris IP Filter (Tasks)

Part IV Mobile IP

27.  Mobile IP (Overview)

28.  Administering Mobile IP (Tasks)

29.  Mobile IP Files and Commands (Reference)

Part V IPMP

30.  Introducing IPMP (Overview)

31.  Administering IPMP (Tasks)

Part VI IP Quality of Service (IPQoS)

32.  Introducing IPQoS (Overview)

33.  Planning for an IPQoS-Enabled Network (Tasks)

34.  Creating the IPQoS Configuration File (Tasks)

35.  Starting and Maintaining IPQoS (Tasks)

36.  Using Flow Accounting and Statistics Gathering (Tasks)

37.  IPQoS in Detail (Reference)

Glossary

Index

IPsec and SCTP

The Solaris 10 release supports the Streams Control Transmission Protocol (SCTP). The use of the SCTP protocol and SCTP port number to specify IPsec policy is supported, but is not robust. The IPsec extensions for SCTP as specified in RFC 3554 are not yet implemented. These limitations can create complications in creating IPsec policy for SCTP.

SCTP can make use of multiple source and destination addresses in the context of a single SCTP association. When IPsec policy is applied to a single source or a single destination address, communication can fail when SCTP switches the source or the destination address of that association. IPsec policy only recognizes the original address. For information about SCTP, read the RFCs and SCTP Protocol.
Previous Next